my wife and i both have a pt2, she is using hers on a ego winder and i am using an mvp v2, my question is what is a good resistance for replacement heads that will work for both. i have my MVP down to 3.7v or 6w, anything over that i get a burnt taste, but on the ego 4v is good, any ideas or advice to eliminate the burnt taste?
protank 2 question
- Thread starter saintsfan
- Start date
- th_trl_thread_readers 0
- Status
I'd get the 2.5 ohm heads. The higher the resistance, the less power the heads will see at a set voltage. Too much power = burnt juice
Last edited:
that's what i was thinking, wanted to get some advice first. also what about removing one of the flavor wicks, what is the advantage,more flavor?
i will try the 2.5 without removing flavor wicks first, thanks for your info wings.
Your welcome. You can always try removing a flavor wick from your current heads to see if it was dry hits causing the burnt flavor, just don't throw it away. If it starts flooding, just reinstall it. Always glad to help a fellow vaper!
I find protank 2 works best on 2.2 coil heads for vaper, TH & flavor. Also keep in mind the flavor wick might
help to prevent juice from spitting into your mouth!
help to prevent juice from spitting into your mouth!
This is great advice. I use organic cotton from CVS and it's only about $4 for a large bag.
KangerTech Chart came with all my Protanks 2's.
Suitable Voltage to different Resistance
1.7 - 1.9 ohms / 3.1 - 3.3 volts
2.1 - 2.3 ohms/ 3.4 - 3.7 volts
2.4 - 2.6 ohms/ 3.8 - 4.1 volts
2.6 - 3.0 ohms/ 4.2 - 4.5 volts
Suitable Voltage to different Resistance
1.7 - 1.9 ohms / 3.1 - 3.3 volts
2.1 - 2.3 ohms/ 3.4 - 3.7 volts
2.4 - 2.6 ohms/ 3.8 - 4.1 volts
2.6 - 3.0 ohms/ 4.2 - 4.5 volts
- Status
Similar threads
- Locked
