Ok so my DNA 60 big screen came and I dig it! I do like the larger screen much better than my DNA 40 small screen.
Now............... I also snarfed up a Billet Comfort because I haz about 300 Aspire coils in stash and I figured with the comfort I can also use them in the BB if I want..
But................ How in tarnation do you get the dern thing in? Okay I think I haz figured it out but man O man is it suppose to be difficult...
Here is what I finally did to get the contraption in the tank and the tank to fit inside the BB...
1. Screw adapter on bottom of coil
2. Insert coil into tank
3. Put chimney in from the top of Boro
4. Screw the chimney into the coil
5. Seat the assembled contraption into the bottom of the tank
6. Put tank in BB
#4 is a serious pain in the rump since the chimney has to be inside the tank from the top and the coil has to also be in the tank. How in tarnation am I suppose to hold the coil while I screw the chimney on? Is there an easier way to do this? If not this comfort contraption might end up getting chucked right into da trash...
What say the peeps who haz the Comfort....
Edit to add:
Is this the best way for #4
Put the coil inside the tank then push it up through the top tank hole and then screw the chimney on. After that push the whole contraption back into the tank and go, go, go?
Still a massive pain in the rump.........
What color are you after?
I still haz an Uno but was looking at the Insider.. Anyone haz it and wanna comment? I know they are nowhere to be found but might start stalking for one if it's worthwhile..
Well hold on there cowboy..........
Figuring I might have jacked something up settings wise when trying to figure out how to access the various settings, I found the DNA 60 manual and went through all the settings and set them to what I think they should be... It's been vaping fine for the past 30 minutes...
Is it possible I inadvertently changed a setting that could have caused the "Ohms too low" error?
I sent BB a message but I'll keep an eye on this puppy and see if that rears it's fugly head again.. I hope not....
I posted a question about the Insider leaking issue on their FB group and they replied very quickly via PM, giving me a detailed rundown of what could be causing the issue, complete with photos. Their customer service is absolutely outstanding, but I would expect nothing less from a high end modder. It appears that I failed to push the tips of the wicks into the juice channels, which is definitely user error on my part. I'll rewick the Insider tonight when I get home from work and see if the correct wicking resolves the issue.
As an aside, the Insider is a flavor chaser's dream. So far, I tried three different e-liquids in it (Phillip Rocke Grand Reserve Crème de la Crème, Five Pawns Nona and ANML Carnage) and it greatly enhanced the flavor of all three. I really don't see myself going back to using the Nautilus coils in my BB4.
Would you be able to post their response and pics, or send in a message on ecf?
Just rewicked mine and this time to much wick, so rewicked again and seeing how this works.
I'm going to give the above a bid tomorrow. I'm not getting good flavor from mine. May be too little wicking.
I'd go as far as saying that the flavor I'm getting from the Insider is better than what I've gotten from any RTA I've used with other mods and better than my trusty Radius/Kabuki setup. Definitely try the Stram Tuners instructions I posted above, they work perfectly!