Dismiss Notice
ACT NOW!! Stop the FDA from banning nearly ALL vaping products from the market! Support the "Cole Bill" now: CLICK HERE for details

Atty mech mod gap is killing me

Discussion in 'Ask The Veterans' started by Cabusi, Apr 22, 2014.

Thread Status:
Not open for further replies.
Image has been removed.
URL has been removed.
Email address has been removed.
Media has been removed.
  1. Cabusi

    Cabusi Full Member

    Mar 25, 2014
    San Francisco, CA
    Anyone know where I can get a washer (brass preferred, steel ok) to fix this gap? I've tried everything to adjust and it's just not working out. The gap is killing me. Genuine Zenith V2 on a genuine Givo mod. Thanks for any help/advice.

    Attached Files:

  2. steved5600

    steved5600 Ultra Member Verified Member ECF Veteran

    Sep 7, 2012
    Dallas, Texas
    Can't tell you where to find it but the washer will need to be 22mm outside diameter. Could get one with most any size inner hole and custom drill and tap it to fit on the 510 threads. Have no idea of what gap you will have to measure that. My advise don't bother just live with it going to be hard to find in the thickness you need. One other possibility would be a hybrid kit but have not seen one for those.
Thread Status:
Not open for further replies.

Share This Page