More/less cotton? Coil positioning ? Wick positioning ? I would appreciate any and all advice . This is an igo w with drilled out air holes. vaping on a mech
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
More/less cotton? Coil positioning ? Wick positioning ? I would appreciate any and all advice . This is an igo w with drilled out air holes. vaping on a mech View attachment 313981 View attachment 313982 View attachment 313983
Sent from my iPhone using Tapatalk
You can also tr moving the coils a bit towards the center next time for easier stuffing and cleaner look. (Not to mention getting more air directly on the coil rather than on an angle)
I actually just cut the tails as Smexly suggested the width of the deck and vape is great. I think I'm gonna move the coils up just a fuzz. That way they can get alil more air over the coils . It was alil warm
Sent from my iPhone using Tapatalk
Moving the coils up will increase TH. Like others say above, closer to the edge of the deck and air source will produce a better vape with less TH.
The heat is not caused by coil position, it is that the resistance is lower than your sweet spot. To reduce heat you would want to increase resistance
And FYI those look a little bigger in diameter than a micro coil.
Here's a fact sheet to clear up the confusion created by the you tube vid jocks:
Thanks that helps a bunch and expanded my noobular mind I used the smallest rod in the artistic gizmo set . I measured it at 0.062"/1.59 mm on my calipers .
Sent from my iPhone using Tapatalk