1. Take part in the #WeAreVapor campaign

    Dear Guest, 

    The  #WeAreVapor campaign has just launched and needs your help. This is a massive push to get vapers and vapor businesses visible, and make Congress aware of the Cole-Bishop amendment. It is being organised by the Vapor Technology Association. 

    Please take a minute of your time to take a look at the site to see how you can get involved. 

    Thanks!

    Dismiss Notice

Need Help.. Not firing. GLV-3

Discussion in 'GreatLakesVapor' started by aruga, Apr 30, 2012.

Thread Status:
Not open for further replies.
Image has been removed.
URL has been removed.
Email address has been removed.
Media has been removed.
  1. aruga

    aruga Senior Member Verified Member ECF Veteran

    Oct 27, 2011
    VA
    Hello all. Very frustrated. The GLV-3 was working great then all of a sudden it sopped firing.
    I remvoed the GLV from the feeder, tried different attys, cartos, and batteries. I then adjusted the center pen using the ball and hex screw and it still won't fire.
    I put a nice tank on the GLV then adjusted the center pen and got it tight, loosed end back and still won't fire. I think something is damaged in the head cap where the button is. Any thoughts?

    I really appreciate any feedback
     
  2. BluSwatch

    BluSwatch Crazy Mod Collector Verified Member ECF Veteran

    Supporting member
    Nov 20, 2011
    Washington
    Not sure what to tell ya aruga .... my GLV3 Mini doesn't have a center pin, it has a ring type of thing for the feed needle to go up thru. I have had a couple of my GLV2s go off a bit to where I had to adjust them a couple of times.
    Maybe call Jay and Sara tomorrow and ask them?
     
  3. ksmith

    ksmith Vaping Master Verified Member ECF Veteran

    Feb 13, 2011
    Colcord, Oklahoma
    My GLV3 Mini did that once on me. I cleaned it real good and put nolox on the threads and the center where the battery makes contact and it started working like a champ again. Hope this helps.
     
  4. aruga

    aruga Senior Member Verified Member ECF Veteran

    Oct 27, 2011
    VA
    Thanks for the advice.
    I spoke with Jay and apparently mine has a bad capacitor or resistor so it had to be shipped back for repair. I just received it back from pain and repair a week ago, but Jay said they did not replace internal parts if the device is working correctly. Makes sense to me.
    Apparently there was a bad batch of those things and some have been fixed, and now it's mines turn.

    Again thanks to all who posted.
    Aruga
     
Thread Status:
Not open for further replies.

Share This Page