rewire a vision spinner 2

[thijs]

hello.

yesterday i broke my vision spinner 2 in half

what i have left is a battery with a visible circuit board in it

the other half is the center pin with two wires; a black one and a yellow one what is all attached together.

so my question is where on the circuit board do i need to attach the wires?
and i see it was attached with some sort of glue, or can just solder it with tin?

or should i just buy another one?

thanks!

 

[r77r7r]

That was common a few years back with the looong Twist batteries. Usually in the trash....

 

[thijs]

allright, but the problem is there are no smaller vv twist batteries only very long ones
do you have a recommendation for a small vv device?

i like the vv because even with 1.5 ohms on a standard 3.7 with the kanger coils there is not much vapor

 

[thijs]

altough it looks like i can repair it easily with just solder it back together i just dont know where the wires go

 

[hurricanegirl100]

Plastic surgery to repair my blown off face would hurt! and cost a lot more than a new Spinner. Dude, splurge..