Smoktech magneto and RSST

Discussion in 'Ask The Veterans' started by muslenutz, Dec 1, 2013.

Thread Status:
Not open for further replies.
Image has been removed.
URL has been removed.
Email address has been removed.
Media has been removed.
  1. muslenutz

    muslenutz Full Member

    Joined:
    Nov 21, 2013
    Location:
    USA
    Thinking of going to mechanical mod but I have a few questions if I am going to be using this. I also plan on buying the smoktech RSST.

    Do I need and ohm meter or can I just put it on a itaste vv/vw? Do I really need to spend the $20 bucks? I dont want to blow myself up.


    Mesh, 400 seems decent for 60/40 and 70/30 Juice?


    Torch to oxidize or can I just use a lighter?


    Kanthal Guage? Was thinking 32 to start. I usually use 1.5 or 2.1 coils.


    Can I still use Smoktech DCT tanks, iclears 30s, pro tank 2 or the clear 16s with an adapter?

    What can I expect from the hit compared to the mvp I have?



    Thanks!
     
  2. tmcase

    tmcase ECF Guru Verified Member ECF Veteran

    Joined:
    Apr 20, 2011
    Location:
    Rave's neighbor!
    It's a really good idea to have a multimeter but testings ohms on a iTaste will suffice if your iTaste is accurate.

    400 mesh is fine and I've found that 500 mesh is better for high VG.

    Torch to oxidize.

    32 ga kanthal is great unless you plan to make micro coils then you'll want 28ga wrapped around a 1/16th drill bit. 32 ga is perfect for the ohms you mentioned.

    Adapter question....yes.

    Can't help you with the last question. Sorry.
     
Thread Status:
Not open for further replies.

Share This Page