Tailpiping has solved some of my problems :)

Discussion in 'Tips and Tricks' started by geeker, Oct 11, 2009.

Thread Status:
Not open for further replies.
Image has been removed.
URL has been removed.
Email address has been removed.
Media has been removed.
  1. geeker

    geeker Ultra Member Verified Member ECF Veteran

    Joined:
    May 12, 2009
    Location:
    Neither here nor there
    I've been switching back and forth betweem a 901 Prodigy and a 510 Protege. I've been dripping, and after 2 or three good puffs, I was getting a scorched flavor out of any juice I tried, even the HV juice.

    On a whim, I decided to tailpipe. I think the more concentrated draw on the atty must have cleaned some gunk off of them, because now they work great. Even my homemade juice doesn't burn.

    Maybe it has to do with the increase in air through the atty. Yes, the attys get hot on my lips, but I just have to let off for a couple of minutes and it's fine. Come to think of it, analogs were hot on my lips, too.

    Anyway, hope this helps someone. Give it a shot and let me know if anyone else has a similar experience.
     
  2. TDM

    TDM Moved On ECF Veteran

    Joined:
    Apr 5, 2009
    Welcome to the dark side of the dripping tailpipers!! :lol:
     
  3. doots

    doots Vaping Master Verified Member ECF Veteran

    Joined:
    Aug 22, 2009
    Location:
    central texas
    I use a mouthpiece without any filler material. Takes the heat question out of the equation altogether.
     
  4. geeker

    geeker Ultra Member Verified Member ECF Veteran

    Joined:
    May 12, 2009
    Location:
    Neither here nor there
    That's what I have been doing, but still getting a scorched taste. Must be the increased airflow. Honestly, I don't mind the heat.:evil:
     
  5. emus

    emus Vaping Master ECF Veteran

    Joined:
    Jun 9, 2009
    Tailpiping is the best IMO.

    M401 and RN4081 are great tailpipe ecigs; just cut end off cart.

    510 tailpiping is a bit hard; metal on lips instead of plastic.
     
  6. Brachinus

    Brachinus Super Member ECF Veteran

    Joined:
    Sep 28, 2009
    Location:
    Jersey Shore
    I've been tailpiping my 510 at the end of the day, although I didn't know it was called that until just now.

    I just take off the cart and have a couple puffs on the atty before I blow it out and burn it off for nighttime storage.

    I've been toying with the idea of an atty insert for dripping, that would act like an internal cart keeping many drops of liquid next to the bridge, and letting someone vape without a cart for more than a few puffs before topping it off. The trick, I guess, would be making it porous enough that air could come through but not so much that liquid would drip through to the bottom of the atty.

    I suspect the best you'd get would be something in between dripping and using a cart, although with a 510 you might be able to make it last as long as most people use the cart before topping up.
     
  7. breakfastchef

    breakfastchef Moved On

    Joined:
    Feb 12, 2009
    The best part of tailpiping, particularly at higher voltages, is knowing when you have run your atomizer too hot. That is a big reason folks burn out atomizers - running them too hot for too long. Tailpiping provides very good tactile feedback helping to stem this problem.
     
  8. YoMike

    YoMike Senior Member ECF Veteran

    Joined:
    Sep 15, 2009
    Location:
    Maui HI
    I've tried everything and I found that a filled cart with the tea bag mod gives the best flavor.
     
  9. ProfessorDaffy

    ProfessorDaffy Super Member ECF Veteran

    Joined:
    Jun 12, 2009
    Location:
    Acme Looniversity
    Maybe there should be a sliding scale base on layers of skin removed? Blisters per square inch?

    I could almost see tailpiping a 901 (though I'd feel silly doing that in public, but it's bound to impress your date!) but the 510 gets too hot. Sounds more like his atty would perform better from a good old fashioned soaking.

    --Prof Daffy
     
  10. PaulZ

    PaulZ Senior Member ECF Veteran

    Joined:
    Sep 26, 2009
    i did this a few time with my 510 when i put a little too much juice in the cart; so i dont get "liquid in the mouth" syndrome :p it gets a bit warm, but its not horrible. i wouldnt do it all the time, i like the concentrated stream from the little hold better than tailpiping it.
     
  11. Robert

    Robert Moved On

    Joined:
    Jun 18, 2009
    Location:
    San Diego, CA.
    Tailpiping- Finally we have a term for it-

    Next someone will mod something- like a little leather piece to go around the pipe.- lol

    When I read tailpiping- I was gonna say don't forget to clean under you fingernail- but I gueass I was thinking of something else
     
  12. geeker

    geeker Ultra Member Verified Member ECF Veteran

    Joined:
    May 12, 2009
    Location:
    Neither here nor there
    LOL! I did not coin the term, but it does seem fitting, wouldn't you agree?

    I was thinking the rubber/silicon sleeve that comes with the cartomizers might reduce some of the heat.

    Maybe I will just change my name to Hot Lips.
     
  13. Johnny Blaze

    Johnny Blaze Forum Supplier ECF Veteran

    Joined:
    Aug 11, 2009
    Location:
    Tampa, FL
    What the heck is tailpiping? Sounds like something you'd find in a San Francisco bath house...lol

    Johnny Blaze
     
  14. Snarkyone

    Snarkyone Super Member ECF Veteran

    Joined:
    Sep 4, 2009
    Location:
    Your mom said not to say...
    Tailpiping is taking a hit from the E-cig without the filter attached on the 510 or with the end cut off the filter on a m401 model so it is open ended like a tailpipe on a car exhaust.
     
  15. Stormynights

    Stormynights Vaping Master Verified Member ECF Veteran

    Joined:
    Mar 31, 2009
    Location:
    Bristow, Ok.
    If you bite the end of a 510 cart the end will pop out. Take out the inner part that holds the juice. No more burned lips.
     
  16. Drumonron

    Drumonron Ultra Member Verified Member ECF Veteran

    Joined:
    Sep 25, 2009
    Tailpiping you guys kill me and this is something I gotta try...thanks!
     
  17. Brachinus

    Brachinus Super Member ECF Veteran

    Joined:
    Sep 28, 2009
    Location:
    Jersey Shore
    The end of a whistle-tip 901 cart will also pop out, although maybe not with biting (it's stuck inside the outer rim). Probably a toothpick or paperclip would pop it out, or you could do what I did and drop your e-cig on a concrete floor. ;)
     
  18. vapomike

    vapomike Super Member ECF Veteran

    Joined:
    Sep 23, 2009
    Location:
    Hickory, NC (USA)
    I have the 510, and I do this when I'm at home and trying different flavors out. I like the direct hits and I don't have to draw nearly as long as I normally would with the cart to get an equivalent hit. So the heat doesn't really bother me. I admit I was nervous about it at first but now it's like whatever.
     
  19. Reboot

    Reboot Senior Member ECF Veteran

    Joined:
    Oct 9, 2009
    Location:
    Southern Maine
    :shock: Mister Blaze.
     
  20. MHR7331

    MHR7331 Super Member ECF Veteran

    Joined:
    Sep 14, 2009
    Location:
    SoCal
    Stuck a rubber pen grip on my 510 atty as shown in DaMulta's drip-friendly cart vid, and it's working GREAT. No more fidgeting with the stupid cart to drip...
     
Thread Status:
Not open for further replies.

Share This Page