1. Win Vaping gear! The ECF 15 Millionth Post contest

    We are fast approaching the 15 millionth ECF post and we have a contest to celebrate this huge landmark and amazing prizes to give out to our members! Head over to the official contest thread to see the rules and check out the prizes generously pledged by our registered suppliers on the prize announcement thread.

Winding A Coil Using A 4-40 Machine Screw

Discussion in 'Clearomizers' started by spider362, Mar 17, 2013.

Thread Status:
Not open for further replies.
Image has been removed.
URL has been removed.
Email address has been removed.
Media has been removed.
  1. spider362

    spider362 Ultra Member Verified Member ECF Veteran

    Joined:
    May 27, 2010
    Location:
    Raleigh, NC
    Found this video on winding a new Kanger T3 coil using a 4-40 machine screw though it seems the process can be used for anything else.

    This is not my video, I just found it and though I'd post it.

    Go to 4min 16sec for the start of the actual winding.

     
Thread Status:
Not open for further replies.

Share This Page