Search results

  1. trentenmarschel

    Merlin by Augvape and Roxy

    So I am a little upset now. I just cleaned the tank and was putting it back together and I heard this crack sound. I wasn't putting the tank on any tighter than I did before. So I started to look to see what it was and I found this. The film that makes the smoked glass look is on the outside...
  2. trentenmarschel

    Merlin by Augvape and Roxy

    That's strange it fell all the way down there. Mine is in pieces in the sink right now soaking. I am getting ready to rebuild it. Not sure what kind of coil I want to do this time.
  3. trentenmarschel

    Eleaf iStick "pico"

    Yea, I don't use the 1600 one. It lasted like 2 hours the last time I tried it. I just rotate between the 2 2000 mAh for now. I plan to buy batteries this month if I have the extra bucks to spare.
  4. trentenmarschel

    Eleaf iStick "pico"

    These are the batteries I am using. Only the 2000 mAh batteries. The 1600 doesn't last very long. But the other 2 last me almost all day. I don't go over 25W. I tried doing 75w once and it said Week battery. If I use the mod until the battery is completely dead it will give the device too hot...
  5. trentenmarschel

    Eleaf iStick "pico"

    Yea, I normally don't go anywhere over 25W I never feel it getting hot. I know my batteries are old. I bough them brand new with my Lavatube 2.5 when it came out. Does anyone know if the 510 center pin on the pico is magnetic or just spring loaded? It's strange that it somehow shorted out when...
  6. trentenmarschel

    Eleaf iStick "pico"

    Just looked in this thread a little, and I've gotten the "Device Too Hot" message. But its only happened when the battery is pretty much dead. I don't think it has anything to do with the button top.
  7. trentenmarschel

    Eleaf iStick "pico"

    I'll keep that in mind when I buy new batteries. I wouldn't think it would be too bad unless I screw the battery cap on really tight. I just tighten it down to where it is snug. I would have though the positive pin on the Pico would have been spring loaded like most other mods. But It's not...
  8. trentenmarschel

    Eleaf iStick "pico"

    Not sure the batteries I have in there now are the small button top. I think someone said that it would work with flat top, but I am not sure on that. I got it working again, but I can unscrew the tank half way and the ohms don't change. So it's kind of strange that it randomly zeroed out like...
  9. trentenmarschel

    Merlin by Augvape and Roxy

    I would just stuff the ends of the cotton into the wells. I normally use like a flat blade screwdriver for this. If there is too much cotton to fill the holes, then I would trim that extra cotton by the coil. I've had to do this with silica wick. If I have like 3 strands of silica and only 2...
  10. trentenmarschel

    Eleaf iStick "pico"

    This was kind of odd. I was in the middle of taking a draw on the Merlin RTA with it on the Pico, and all of a sudden the vape stopped. I looked at the screen it it showed 0.00ohm. The tank was screwed down all the way, but I was able to tighten it just a small bit and it went back up to...
  11. trentenmarschel

    CCFraud/nic supplier

    Just saw this on the news too. You just can't tell which hack resulted in your card getting breached. Data Breach At Oracle’s MICROS Point-of-Sale Division
  12. trentenmarschel

    Merlin by Augvape and Roxy

    Yes, it the spot where the wick is supposed to site like in this picture. :)
  13. trentenmarschel

    Merlin by Augvape and Roxy

    I used to do the o ring trick on my kayfun all the time. Had it for like 2 years and never replaced an o ring. But if it's leaking out of the AFC then there are still a few things it could be. It could be getting too much juice in the wick and leaking into the air intake. But if there is a not...
  14. trentenmarschel

    CCFraud/nic supplier

    So just got off the phone with the vendor. She said the owner had their IT guy look into it over the weekend, and they also spoke with their card processor. They were not able to find any security breach. They said they use a 256bit encryption on the card information. When a purchase is made all...
  15. trentenmarschel

    Merlin by Augvape and Roxy

    I have to rebuild my Merlin today my notch coil I've had for over a week is starting to taste like junk. I was thinking about trying a hand wrapped dual coil. How well does that work? Also Does it fit with the air flow resistor in?
  16. trentenmarschel

    Merlin by Augvape and Roxy

    Where is it leaking from? The bottom of the glass tank, or the air slots. If it's not the way the wick is setup, It could be that the o rings are getting worn out. You said it was used. If you don't have spare o rings. I made a thread a long time ago on here and it works for me. If the o rings...
  17. trentenmarschel

    Lemon flavor taste like lemon rind??

    Cool thanks. I'll give that a shot.
  18. trentenmarschel

    Kanthal, Titanium, or nickel?

    Just got some new gear recently. A Merlin RTA and a Pico 75w to go with it. Built a Kanthal coil the first time, and I am currently using the included notch coil. What is everyone using now and why? Was going to see about buying some more notch coils because I really like how well it vapes, but...
  19. trentenmarschel

    Eleaf iStick "pico"

    Cool I just noticed that the charger that fits my cellphone and Samsung tablet is the same charger that works with the Pico. Just tested it. That means I can use my car phone charger with my Pico, and never have to worry about my battery dying on me again. Loving this thing even more. :)
  20. trentenmarschel

    Merlin by Augvape and Roxy

    Lol next one there won't be any holes. Just wire and wick submerged in a tank of juice with a one way air valve under the coil. It'll be called the......RBTA rebuildable bubble tank atomizer. :)
Top Bottom
Forums
Products
Vaping.com
Star Suppliers
Blogs
Menu