Search results

  1. steved5600

    Ipv v2 sx330 chip upgrade

    Not a software upgrade if you go to the The Yhiecigar site you will see all the diff versions of the SX330 but no software downloads. The SX350 is software upgradable to 60watts and there may be a diff board soon that will do 100 but Nope I have not heard of a way to upgrade the SX330 short of...
  2. steved5600

    ohms dropping

    At sub ohm level it could be the inaccuracy of the device you are using. Mods are notorious for being less than accurate and some meters are not so good. Also you may have a better connection than before. All measurement devices have a +or- tolerance. A point 1 ohm diff is not much on a...
  3. steved5600

    Single Parallel Coil

    If your talking about taking 2 wires and twisting them to make a bigger wire no because unless you duplicated the process each time the same way you could not count on the results. Length of wire number of turns. Just do your twisting and take a good ohm meter and measure out 1 foot and...
  4. steved5600

    Reverse Battery Stingray Help

    Not recommended. If you get a break in insulation on the battery and hit the fire button you short the battery out. Think you need to go to Fat Daddy's site and order an upgrade kit for you stingray.
  5. steved5600

    Kick or no Kick?

    Kicks don't work in all mods, and are not meant for higher current uses. I tried and gave up on kicks. Two ways to go. One of the newer Regulated mods or just be good with ohms law and go all mech.
  6. steved5600

    Atomizer suggestions for Sigelei 20 watt mod

    Skip the Protank II. Kanger Aerotank is a better choice or the Aspire Nautilus. They both are a close call in a race. Kanger Aerotank MEGA - 101 Vape Aspire Nautilus Kit Original Free Shipping from USA | eBay The new Nautilus BVC's are pretty good but I lean to the Kanger because I can...
  7. steved5600

    There is no law against buying fake purses, so why does ECF not allow clones?

    First off its not ECF that did that it was ECC. Get your facts strait.
  8. steved5600

    Am I the only person who has a problem with ppl making juice in their homes?

    Yea I think you are pretty much the only person who thinks that is bad. Get real. This is a troll. As long as it's not for sale then it is not you worry so but out.
  9. steved5600

    This mod box can't be found anywhere.

    The second one looks like a custom built box mod. A guy on a FB page I"m on built one similar to that only out of brass.
  10. steved5600

    What Do When All Goes Wrong?

    First soap box time. The reason it happened is important. Batteries only vent when you exceed their design limit. So either you have a short in that set up or the build was to low in resistance. You don't say what kind of battery. Make sure you do your ohm work. How to react. I would...
  11. steved5600

    Aspire Nautilus; continued... ]=

    Keep in mind the BVC is a single coil an the others are dual coils. I'd try the old coils maxed out. Beyond that take it back where you got it and let them replace it or look at it. We can't ask you questions since you can't post in this thread you can create it but no post in it. Could...
  12. steved5600

    Want to buy Rebuildable tank dual coil system

    Go with a Fogger v4.x or an Aqua. The Kayfuns are hard to build dual coils on and sometimes flood when you fill them and on rare occasions leak. Never had a Fogger or Aqua leak or flood and they are easy to build. Only thing i don't like about the Aqua is that if you want transparent you have...
  13. steved5600

    Can't Decide- MVP 2.0 or VTR?

    I'd go IPV v2 or 3. Will do a lot and will be there for when you go into stuff you said you would never do like me. Sub ohming and cloud chasing on Rebuildables. LOL
  14. steved5600

    Newbie

    First I'd get a spare battery. I can tell you you will go though that battery quick and then what. You have to stick it on charge and wait a good while for it to charge. Keeping a spare will also be good in case/when it dies.
  15. steved5600

    Specific bottle for filling the KFL 3.1 from fill port

    Most folks including me gave up on using that damn hole to fill it. I put my finger or thumb over the air holes and fill from the top. You may get a flooded wick at first but it works.
  16. steved5600

    ZNA lite is on the way

    It uses up down buttons to change settings. You'll like it. Much easier to change settings.
  17. steved5600

    copper mod threads keep getting stuck!

    Eddie is right get some Noalox® Anti-oxidant Compound . This happens for two reasons. One being corrosion and also juice can get in the threads and make a mess.
  18. steved5600

    kanger coil rebuild question

    Warning you need to do more homework. I promised someone so apologies for the soap box. You need to understand Ohms law and practice battery safety when you rebuild. The total resistance would be 9.2 only if they were in series. Almost nobody does that on repairables. They are in...
  19. steved5600

    why are you subohming on a regulated device?

    OH on some regulated mods you have to go lower in the ohms to get the wattage they claim. I can see someone in a cloud contest wanting that. I don't but who are you to judge. I once made fun of sub ohming and cloud chasers. Who cares if it does no harm and it keeps folks off the nasties.
  20. steved5600

    why are you subohming on a regulated device?

    Ok first sub ohming is not just for mechs. My sx350 diy mod will go to .2 ohms if i chose to. My Dna 30 and IPV v2 will go below 1 ohm if I so chose. So maybe you need to do a little more homework before you make statements like that. As fare as that (oh it's hard to keep my words nice)...
Top Bottom
Forums
Products
Vaping.com
Star Suppliers
Blogs
Menu