Search results

idk if this was covered but i just got mine and built it with 30ga kanthal and cotton on a 6 wrap standard coil. its at about 1.7ohm but for the life of me i cant get it to pull right. really really tight. I fixed the bottom insulator so it lines up with the air holes but it still wont pull. not...

well lets just say this isnt my first modded rda or rba. I bought this thing on a whim because it was only 10 bucks and i was curious to try it out. hit week at first so i decided to play with it and if i went too big and destroyed it i woudlnt care because it was only 10 bucks. I have my...

OK so the other day i received the scar from smok. The original coil really sucked so i rebuilt it with ekowool and 30ga kanthal. Hit better but still sub par. Both coils equaled out to .8 ohm so i though to myself, i should be pumping out way more clouds. I noticed it was drawing really hot...

if this hasnt happened yet im down. Im all over form new brunswick to bridgewater to woodbridge so location really isnt an issue.

was looking for a place to buy the stone from to cut my own wicks... does this seem good? White Rub Stone 60 Grit - Amazon.com

it sure would. Easiest way is like in the video just use some chemical whether its oven cleaner or stripper to remove the anodized coating and then immediately rinse in water to remove any metal eating acid and then polish. When the whole thing like the top cap of an rda is dipped you need to...

brillo or stainless steel wool will brush it. Go in the same direction every time and don't go back and forth. So say you want the grain to go up and down apply even pressure going in the up direction but dont pull it back down, only go up so you get a uniform look. Its very simple and just keep...

i tapped the fill hole with a tap and die set on my rsst and put a screw in. best thing i could have done. and swapped my grommet from a protank. just need to find a tank replacement and it would be the perfect rba

I have an IR thermometer, ill redo my rsst with ss mesh and ill take a reading to check how hot it gets on a dry burn later today or tomorrow

just to contribute from a non dripper stand point. Ive wrapped bct's with both ekowool and xc-116 and i must say that i prefer the xc-116 taste. Using a propane torch to get both materials to white hot i notice a slight taste to the ekowool. In my opinion on a bct they wick the same. My rsst is...

thats pretty crafty of you. gotta do what you gotta do in a pinch haha

how well does the ss rope wick? better than mesh or is comparable. Im debating picking some up

hot water steeping is how i steep all my bottles when i first get them. Nothing beats a nice long steep but for a quick test of any new liquid a nice dunk in hot water for an hour really does the trick

i personally replace the two flavor wicks with a piece of 2mm ekowool and flip the chimney grommet upside down.

that sounds like a sweet way to carry your gear. and free tools while youre at it

im a big fan of the smok rsst and the aga-t2. both are noob friendly but produce probably just as much vapor as say a nimbus just without the ability to run any crazy dual coils or u wicks.

pro tank 2 on it all day. best clearomizer (technically glassomizer) ive used so far.

fast tech is cheap because everything is made local to them. Fast tech headquarters is actually in florida but all the stock is in china. They sell both clones and genuine products at steep discounts. If you dont mind waiting a couple weeks to get your order, they are a great place to get cheap...

try dry burning the coil to remove the chemical/metal taste. that might help

cheese omelette in french. was a huge dexters laboratory fan when i was a kid.