Search results

  1. unloaded

    BF Cyclone AFC

    You could probably do it as a co-op.
  2. unloaded

    Cyclone rda bf vs. rm2

    Mine have the same draw because I drilled the airholes with the same bit. Both were too tight for me as they came originally.
  3. unloaded

    Cyclone rda bf vs. rm2

    I've got both and I prefer the Cyclone. My theory is, whichever you got first is the one you'll prefer. The main reason I like the Cyclone more is because the juice enters at a higher level and leaves more in the atty when excess is sucked back in the bottle. This allows for more vapes per...
  4. unloaded

    Pbsurado Finally Reviews REO

    I liked the review, he said in comments that he likes approaching products from a newbies perspective. I can tell by his follow ups, he's hooked! He just needs a second atty with higher resistance for those times he wants to tone it down. He'll forget all about regulated devices once he figures...
  5. unloaded

    like Pandora's Box....

    I doubt your VV devices were firing the .9 ohm coil at the voltages you selected. Protection circuits probably had them firing at or near the lowest voltage they will do.
  6. unloaded

    Best cheap RBA ?

    My experience with RBA's and thick wire, your Provari will be very limiting. For fat wire and low ohm coils you'll need a mech mod and good batteries. Once I got into RBAs the only action my Provari got was checking resistance of coil builds. I ended up selling it and most of my other gear to...
  7. unloaded

    What is going to heat up faster?

    The 30 will heat up faster but I'm not sure the difference will be that noticeable. Now if you were making 2 ohm coils with 32g and 26g the difference would be much greater. The 26g coil would need a lot longer piece of wire to get the same resistance and it would heat/cool much slower.
  8. unloaded

    Possible Kanthal/Nichrome allergy.

    You sound like you might like a high voltage/ high resistance setup. You can run one at the exact same wattage as a low resistance setup and get a much different experience. It was all the rage when it first hit the scene and a lot of people still prefer to vape that way. LR and sub ohm seem to...
  9. unloaded

    Possible Kanthal/Nichrome allergy.

    You don't have to take them apart, pull the wicks up through the silicone seal and wrap them around the cup. Remove the tip to drip on them or it will fill your air tube. I'm not familiar with VGV or their juice. "100% VG" usually means there is no PG in it, it doesn't mean there is nothing...
  10. unloaded

    Possible Kanthal/Nichrome allergy.

    You don't have allergies, you've got wicking issues. Most of the china made stuff needs tweaking to wick properly, thick VG juices just make it worse. Keep messing with the RBA's you'll get there. I messed with fluxomizers way back and had the best luck using them as drippers. Instead of having...
  11. unloaded

    Any Recs for a Torch?

    I got one of these from Plumbing section at WallyWorld, less than 20$. http://www.walmart.com/ip/Ronson-Tech-Torch/17133679
  12. unloaded

    brass firing pin

    It's got superglue on it, turn harder (but not too hard)to break it free. You also need to screwdriver in the center pin's slot to keep it from spinning.
  13. unloaded

    What ever you do in life of vaping DO NOT DO THIS!

    Hope it wasn't menthol! If it was I hope you made a video of vaping it.
  14. unloaded

    Vaping Nirvana?

    You sound like a prime candidate for a Reo with a Cyclone or RM2 on it. Learning to squonk is a non issue, it took me longer to get used to a 1/16" airhole, and that didn't take long. Price is a factor but not that big of one considering I had a lot of attys that cost more than a Reo. Form...
  15. unloaded

    Xc132 and 28 ga kanthal

    I like the XC132 in my Cyclones with the tail flooded. I didn't have as good results with it in the RM2. To be fair though I cut it short in the RM2 lie I would cotton wicks. I do a micro coi n 1/16" bit and the 132 slides in easily, a little too much actually. I stick something oversized in the...
  16. unloaded

    Pluid

    If you've never tried it before I suggest using something disposable for first try. Maybe a carto or dripping atty. I for sure wouldn't fill up a Reo with it until you know if you like it. And even then you are making a commitment. It's almost impossible to get the taste/smell out of whatever...
  17. unloaded

    Its woodvil time

    I don't have any woodies but I've got grands and mini 2.1's. I use RBA's on all of them. I make my coils slightly under one ohm and they vape the same. The 18490 AW IMR's have the same amp ratings as the 1600 mAh 18650 AW IMR's. They vape the same with fresh batteries, the 18650's last longer...
  18. unloaded

    Its woodvil time

    Thanks for the info on timing. I was kinda hoping I'd missed it, lol. Might have to scrounge up some funds for an 18490 woodie.
  19. unloaded

    Its woodvil time

    When is the woodie sale? I read a few pages back but don't wanna read it all.
  20. unloaded

    Just wondering wick

    I always have a Leatherman on my belt, it has small scissors that are great for cutting wicks.