yesterday I made dual parallel coil, 28g 7 wraps for each coil it gives 0.19 ohm. I tried it out using my efest purple 2100Mah battery with battery voltage was about 3.8. I really liked the result, great flavor and vapor. but, I'm concerned about the safety of the battery. with fresh battery it will giving about 22A which is still under battery discharge current 30A. is it safe to use this setup? does this affect the life of my battery? and if it is safe how long should I wait between each hit?
0.19 ohm and safety
- Thread starter Ak_vap
- Start date
- th_trl_thread_readers 0
- Status
That's 20amps at 3.8 volts. Do not have the specs on that battery so don't know how it will react. What mod are you using. The reason I ask is the closer you get to the resistance of the mod the more the mod becomes the heater. Had a telescoping mod that had gotten some gunk in the theads and did not know it. It was not making as good a connection and the threads themselves were getting very warm. That resistance you are using needs to be used on a good conducting MOD IMO. Like an all copper mod including the contacts.
- Status
Similar threads
