15% of VOLT Cartos - SmokelessImage -SAME DAY SHIPPING!

Status
Not open for further replies.

Natalia

Vaping Master
Supporting Member
ECF Veteran
Verified Member
Aug 27, 2010
3,231
6,259
California
I'm so glad that I found smokelessimage. It looked exactly like the maxx fusion from bloog because it is the same thing and I was happy that I got it. The Volt performs great and I haven't had any customer service issues.

I did a review for the Volt in the review section of the forum.

Thanks so much Eli, I just watched it. Good review and very helpful. :)
 

Imagine

Unregistered Supplier
ECF Veteran
Mar 16, 2011
7,040
13,915
OHIO USA
www.SmokelessImage.com
awesome thanks so much !!!
I'm so glad that I found smokelessimage. It looked exactly like the maxx fusion from bloog because it is the same thing and I was happy that I got it. The Volt performs great and I haven't had any customer service issues.

I did a review for the Volt in the review section of the forum.
 

Katya

ECF Guru
Supporting Member
ECF Veteran
Verified Member
Feb 23, 2010
34,804
120,147
SoCal
My cartomizers arrived yesterday and I filled one last night and have been vaping away today. Really putting it to the test with sweetened, dark caramel-like juice. You know the one that kills cartos in a day... so far I've topped off three times and not a hint of taste declining. I know it's only been 8 hours, but if this nice warm, clean taste lasts... I'm a total convert. These rate 2.5 ohm every refill so far and I am loving it! :wub:

Will update after the weekend :)

Can't wait for the update, Natalia....:)
 

Natalia

Vaping Master
Supporting Member
ECF Veteran
Verified Member
Aug 27, 2010
3,231
6,259
California
Can't wait for the update, Natalia....:)

It was still going good through last night. I went to refill this morning and found I was out that liquid, so I rinsed it under tap water, and the filler looked really good... fluffy and white. I filled it with PG and into the cleaning can it went.

(BTW, Thank you for that tip Katya, keeping PG in them;))

I really like these, so far. I hit it pretty hard at night for 4 nights and no burnt taste. Though I didn't give it an autopsy to see for sure, but if it's burnt, I didn't taste it.

The filler is a lot looser than other 808 cartos I've used. Maybe that's why it rinsed so well??
 

Imagine

Unregistered Supplier
ECF Veteran
Mar 16, 2011
7,040
13,915
OHIO USA
www.SmokelessImage.com
awesome so glad you are liking your volts!
It was still going good through last night. I went to refill this morning and found I was out that liquid, so I rinsed it under tap water, and the filler looked really good... fluffy and white. I filled it with PG and into the cleaning can it went.

(BTW, Thank you for that tip Katya, keeping PG in them;))

I really like these, so far. I hit it pretty hard at night for 4 nights and no burnt taste. Though I didn't give it an autopsy to see for sure, but if it's burnt, I didn't taste it.

The filler is a lot looser than other 808 cartos I've used. Maybe that's why it rinsed so well??
 

Katya

ECF Guru
Supporting Member
ECF Veteran
Verified Member
Feb 23, 2010
34,804
120,147
SoCal
It was still going good through last night. I went to refill this morning and found I was out that liquid, so I rinsed it under tap water, and the filler looked really good... fluffy and white. I filled it with PG and into the cleaning can it went.

(BTW, Thank you for that tip Katya, keeping PG in them;))

I really like these, so far. I hit it pretty hard at night for 4 nights and no burnt taste. Though I didn't give it an autopsy to see for sure, but if it's burnt, I didn't taste it.

The filler is a lot looser than other 808 cartos I've used. Maybe that's why it rinsed so well??

Thanks, Natalia.

I love loose filler, and I prefer the 'blanket' type over the 'cotton' type. Overstuffed carto is a kiss of death. No airflow to the coil, no proper heating or cooling, and poor wicking.

The only worry I have about these cartos is the burning/melting of something at the base (silicone cup? adhesive?) that I experienced with similar model from a different vendor. But it looks like the Volts don't have that problem. Very good news, indeed.

Oh, and you're welcome. I like my PG flush. Works with atties and cartos.
 
Status
Not open for further replies.

Users who are viewing this thread