I can't seem to build a coil that wont melt when I test fire it. I'm wrapping around a wire coat hanger. Has to be a smaller coil (not much room in this Atomic) I tried starting small, working my way up. either the leads pop on activation, or it has one wrap in the middle that pops while attempting to even the flow of heat.
22 GA Nichrome 60 - issues, advice?
- Thread starter d43m0n1k
- Start date
- th_trl_thread_readers 0
- Status
I would just torch it before install and then only fire it with wet wick installed or don't use a fully charged battery
Last edited:
- Status
Similar threads
