I came up with this yesterday and wanted to share. I've been wanting to use my 306 on my eGo with the cone but the cone is too long and the 306 atty with the basic drip tip is too short. So I realized the 306 atty tapers a bit for the tip to fit tightly. I wanted the tip to tighten onto to atty higher so I just wrapped the top of the atty with a small strip of Scotch tape. The tape has allowed the tip to fit tightly along the top edge and has made the tip long enough to fit perfectly out of the cone.
I also de-bridged the LR 306 which has been a beautiful thing, more vapor and less flooding.
I hope this helps someone.




I also de-bridged the LR 306 which has been a beautiful thing, more vapor and less flooding.
I hope this helps someone.



