5 volt auto mod

[bepsage]

I was thinking about using the mv 510 auto switch and wiring up the switch to the 5 volt regulator with control pin and ditch the little board atached the the auto switch and as a added benifit not have a cutoff time of the normal setup and so i can use dual coils on it better

I'm pretty sure this is how mv makes there 5 volt and vv just want to make my own a little smaller any sugestions are gladly accepted

 

[bepsage]

I sketched up the basic plans so anyone can throw out ideas or not



its not the best drawing but the main part is there i want to put everythin but the regulator and battery into a dc tube and use heatshrink tubing to atach the regulator and use a mono headfone cable to go to the battery pack tell me what you think

 

[bepsage]

This is what i threw together with the parts i got from mv it works good with my old trust fire battery for the dual coil and everything else its just when i use the new imr battery i got it freezes up and no power goes to the dual coil until i vape down the battery a bit with a single coil so there are more reasons i want to put together something like this than just the 5 volt vaping i just want it to be a good little power head i can plug onto any power pack i make and have it actually perform well as a good auto switch that doesnt have a big battery hanging off it