510 Atty tank.

[Vermonster13]

Did a little experiment today. Took a Boge bridgeless 510 atty, slotted it, filled it with stainless steel mesh that I tamped down tight to where the drip tip reaches, the grommeted it and built a tank. I put the tank on a 510-510 sealed adapter and fired it up. Low and behold it works! The tank only holds 1-1.5 ml of juice and you need to be careful setting the top grommet in for the vacuum effect(I will drill a fill hole in it next I think). It gives great vapor and flavor and after set-up it hasn't leaked.

I used two 5/8 pipe screens for the mesh this time as for it was easy to get some. Everything else is the same materials I use on all my other tanks.

 

[Dalton63841]

I built mine basically the same, but I didn't slot the atty. I just used a 1/16th" hole. I didn't even use the ss mesh. A hole that small doesn't break the surface tension of the liquid, so it doesn't flood. Instead it pulls the joose in little at a time when you puff.

Great work though. I will have to try this out.