510 connection not touching atty maybe ?

[Nick_808]

Hey everyone i just got a new plumeveil by aethertech clone. Ive been using mech mods for about 3 months now and I'm not sure if i received a broken atty or maybe my connections are not even touching. I say this because i have tried single coil, dual coil, high ohms, low ohms my meter is reading it fine but whatever i build on it, it wont fire up. The coils never light up, my other atty fires fine on my mod so i cant see what the problem is here. I am using a panzer mcv 1:1 clone with eh 35a 2500 mah batteries. Am i supposed to move the connections up and down depending on the atty Im using? up until now Ive only used a stillare clone atty no problems whatsoever on that one. please help if you have any tips of whats going on i really wanna use this rda !!! thanks vape on

 

[JKnight5]

You have to adjust the center pin under the top cap of the mod to make a battery connection. Every atty is different. Check that, and see if it works


Sent from my iPhone using Tapatalk

 

[zoiDman]

Not sure if this will help the OP or Not. Because I Don't own this Mod. But this Video may give him some Ideas.

 

[crxess]

If your meter reads your final ohms, your RDA is ready to use.(No shorts - Not open)

Now, is your Panzer adjustable(threaded), Spring loaded or Floating pin?

Contact is your issue.

 

[Nick_808]

my panzer is adjustable it has a Adjustable positive contact pin for battery rattle with Brass contacts. and i will watch the video now and try

 

[Nick_808]

@zoidman YOOOOO that fixed it, i just had to hammer down the part under the top cap so the pin gets pushed up now its lighting up YESSSS THANKS GUYS !!!

 

[zoiDman]

@zoidman YOOOOO that fixed it, i just had to hammer down the part under the top cap so the pin gets pushed up now its lighting up YESSSS THANKS GUYS !!!

I can't take the Credit. You Fixed it. With the Help from that Dude on the Video. I only showed you what Drawer in the Tool Box to find the tool you Needed.

Good to hear that things worked out.