510-t problems and leaking
- Thread starter yongsheng11
- Start date
- th_trl_thread_readers 0
- Status
hi yongsheng11 and welcome to ECF
..i started on the same 510-T like U..so i am familiar with yr dilemma..a leaking atomizer/tank set up..so this what i do to prevent leak..i do not remove my cap for refill(the reason is U do and do not secure properly will leak,so dont)
u need to puncture yr new tank(jammed into yr atomizer..so when u done that..if U can remove the flap ..good if not it is still ok to proceed but best if U could using a tweezer)..next U inject yr juice into the hole U done by syringe(do not fill till full..leave 2mm of air pocket.
next with the filled tank..the tank must be in a position facing U(north)..and atomizer slotted in,south(in doing so the pressure of the filled tank will not push out the juice(if U do the wrong way,some juice spill over yr hand).. put in yr atomizer securely,namely must make a clicking sound as u insert the atomizer to the tank(try and also lined up,the shape of yr tank to the atomizer..yr tank shape is round but the insert is not..it is elongated (not square or round)..this U match with the plate of the atomizer..so with the filling done..i am sure U will not have a leaking tank in future..but daily maintenance as U vape..condensation build up in the tank chamber(use Q-tip after removing the hard cap to clean)..no need to clean atomizer,just a good blow on both ends be4 each refill..if it is working properly dont do anything,my atomizers has lasted me 8 months and still ok but i replaced with new ones..a good tip to rotate usage of atomizers..hope it is clear what i trying to tell U..regards mafig
..i started on the same 510-T like U..so i am familiar with yr dilemma..a leaking atomizer/tank set up..so this what i do to prevent leak..i do not remove my cap for refill(the reason is U do and do not secure properly will leak,so dont)u need to puncture yr new tank(jammed into yr atomizer..so when u done that..if U can remove the flap ..good if not it is still ok to proceed but best if U could using a tweezer)..next U inject yr juice into the hole U done by syringe(do not fill till full..leave 2mm of air pocket.
next with the filled tank..the tank must be in a position facing U(north)..and atomizer slotted in,south(in doing so the pressure of the filled tank will not push out the juice(if U do the wrong way,some juice spill over yr hand).. put in yr atomizer securely,namely must make a clicking sound as u insert the atomizer to the tank(try and also lined up,the shape of yr tank to the atomizer..yr tank shape is round but the insert is not..it is elongated (not square or round)..this U match with the plate of the atomizer..so with the filling done..i am sure U will not have a leaking tank in future..but daily maintenance as U vape..condensation build up in the tank chamber(use Q-tip after removing the hard cap to clean)..no need to clean atomizer,just a good blow on both ends be4 each refill..if it is working properly dont do anything,my atomizers has lasted me 8 months and still ok but i replaced with new ones..a good tip to rotate usage of atomizers..hope it is clear what i trying to tell U..regards mafig
Last edited:
i never knew it was a cap, i have never been even able to remove a cap? i just use a syringe to put the liquid in there. Can u suggest something from Vapebar.com.au because the shipping from there may be quite expensive since im from australia
- Status
Similar threads
