The costs of running this huge site are paid for by ads. Please consider registering and becoming a Supporting Member for an ad-free experience. Thanks, ECF team.

510 thread measurements?

Discussion in 'Bottom Feeder Mods' started by Hightech Redneck, Mar 4, 2018.

Thread Status:
Not open for further replies.
Image has been removed.
URL has been removed.
Email address has been removed.
Media has been removed.
  1. Hightech Redneck

    Hightech Redneck Vaping Master Verified Member ECF Veteran

    Mar 27, 2015
    N C
    Ok short story is I ordered a cheap clone squonker.
    Had bad threads.
    Drilled and basically press fit a 510 sleeve in. Has good conductivity, but in the process of cutting and pressing it I goofed the threads a little.
    Does anyone know the tap size I need to clean up the threads? 510 don't mean Jack, have figured out it's 7mm but nowhere locally has what I need.
    Can't order one online without knowing exactly what I need.

    I could always drill out and start over but would really just like to clean up what is almost a finished project.
    And I would always be prepared once I have the tap.

    Thanks in advance.
     
    • Like Like x 2
  2. Izan

    Izan Vaping Master ECF Veteran

    Jul 1, 2012
    Mallorca, Spain
    • Winner Winner x 3
    • Useful Useful x 1
  3. Hightech Redneck

    Hightech Redneck Vaping Master Verified Member ECF Veteran

    Mar 27, 2015
    N C
    • Like Like x 2
    • Agree Agree x 1
  4. Rossum

    Rossum Surly Curmudgeon Verified Member ECF Veteran

    Supporting member
    Dec 14, 2013
    NE FL
    Yep, M7 x 0.5
     
    • Agree Agree x 2
    • Useful Useful x 2
Thread Status:
Not open for further replies.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice