Ok short story is I ordered a cheap clone squonker.
Had bad threads.
Drilled and basically press fit a 510 sleeve in. Has good conductivity, but in the process of cutting and pressing it I goofed the threads a little.
Does anyone know the tap size I need to clean up the threads? 510 don't mean Jack, have figured out it's 7mm but nowhere locally has what I need.
Can't order one online without knowing exactly what I need.
I could always drill out and start over but would really just like to clean up what is almost a finished project.
And I would always be prepared once I have the tap.
Thanks in advance.
Had bad threads.
Drilled and basically press fit a 510 sleeve in. Has good conductivity, but in the process of cutting and pressing it I goofed the threads a little.
Does anyone know the tap size I need to clean up the threads? 510 don't mean Jack, have figured out it's 7mm but nowhere locally has what I need.
Can't order one online without knowing exactly what I need.
I could always drill out and start over but would really just like to clean up what is almost a finished project.
And I would always be prepared once I have the tap.
Thanks in advance.
