555 and FET PWM power controller MOD

[Dragon@HEC]

Very nice mod Dragon
love the pwm circuit really would like to make one myself. Sometimes you feel like a nut sometimes you don't kind of thing. High power for a strong vape and lower for a less powerful would be a plus to a mod

Thank you for the comment,traderdan.
It enjoys oneself over an electronic cigarette by a conception possible by my knowledge.
It thinks an electronic cigarette today to be good when more various adjustments can be done according to the favor because there are a lot of still inflexible parts.
Smoke not only is scattered by high power but also it is done that it is also good to taste the liquid deliberately by low power massaging it.

Let's enjoy an electronic cigarette MOD!

 

[traderdan]

Dragon
I've been to your web site and seen the videos they were cool but reading your site is impossible even with the translator program for goggle . I would really like to read about the build and make one myself can you do a build thread on the chopper circuit or make a more details schematic for the non- technical electronics people like myself .
thanks a ton Dan

 

[bionic1]

add Force sensitive resistor.
like this
DIY Force Sensitive Resistor (FSR)

push harder, more current, more vapor

Rocketman

This looks nice...

 

[traderdan]

Hi Dragon @ hec
Found a really cool chip wanted you to look at it and tell me what you think could do everything your pwm does and some more with the right app.. I'm interested to see what you think .
Dan
http://focus.ti.com/lit/ds/symlink/tps54620.pdf

 

[Dragon@HEC]

Dragon
I've been to your web site and seen the videos they were cool but reading your site is impossible even with the translator program for goggle . I would really like to read about the build and make one myself can you do a build thread on the chopper circuit or make a more details schematic for the non- technical electronics people like myself .
thanks a ton Dan

Thank you for the comment,traderdan.
The in-depth explanation has a difficult part any further though I also understand to the electric circuit an inexperienced person's having a difficult part.
The method of mounting on the substrate including VR is guided on the updated page, and refer also, please.

modranaito.blogspot.com/2010/04/vr.html

Moreover, I cannot mount an equal circuit on IC.
We will recommend building in the battery case to be tried after test MOD is confirming the operation made including because there are not too much a lot of parts either.

 

[Dragon@HEC]

Hi Dragon @ hec
Found a really cool chip wanted you to look at it and tell me what you think could do everything your pwm does and some more with the right app.. I'm interested to see what you think .
Dan
http://focus.ti.com/lit/ds/symlink/tps54620.pdf

Thank you for the comment,traderdan.
There is a problem mounted upper some though it is introductory IC.

1.Processing of feedback circuitry (VSENSE).
It is easy if it is a constant voltage circuit, and cannot adjust this part for the chopper control.
It seems that it oscillates along with the change of the output voltage, and it doesn't operate normally.
It is necessary to use the circuit that can be adjusted without using feedback from the output.

2.Frequency.
My circuit assumes about 100Hz though operation by 1.6MHz is assumed from 200KHz in this data sheet.

3.Allowed current.
Ten times or more the current actually thrown are ideals in ratings recommended by power FET though the maximum current is 6A in this IC.
Because a large current of 2A or 4A flows in actual MOD, the possibility of damaging it because of generation of heat etc. is thought in this IC.

Though there only haves to be IC that can clear the above-mentioned.