I got a new High Power 801 kit yesterday and I'm having the darndest time with this thing. I tried all day yesterday fiddling around with different cart mods trying not to get that burnt atty taste and failed with everything. (PTB, blue foam, fluval, polyfill). I just started dripping with it this morning and the atty itself seems to be working fine - supposedly the high power equates to a 5V experience. I went in and looked at everything under some bright lights and did a little measuring. It seems that there is a good bit of distance between the bridge and the bottom of the cart. I believe that this is a "low bridge" atty, but I'm not 100 percent sure of that. Is there any danger in pulling the filling of the cart out a bit so it hits the bridge? I don't mind dripping at home, but I'm going to be in the car later and I also worry about dripping with an auto batt.
