901 carts don't fit anymore

Status
Not open for further replies.

tmcase

ECF Guru
ECF Veteran
Verified Member
Apr 20, 2011
20,862
54,652
I have 901 cartridges that don't fit my 901 atty anymore. The atties are from TW and so are the carts but now some of the carts fit loosely. Has anybody had this problem and have a fix for it? I've tried putting some tape on the carts but the tape gets squished down after a couple refills. Anybody know why this has happened and have a permanent fix besides buying new carts?
 

Ember

Senior Member
ECF Veteran
Verified Member
May 29, 2011
270
240
Tyler, TX
3 fixes:
1. crimp the metal on your atty a LITTLE BIT to stop the cart from popping out... if your atty is flimsy enough.
2. Take a hot thingie (Glue gun tip, smoking hot needle, soldering iron) and make a bump on the side of the cart with the heat to help hold it in.
3. Throw the cart away, get a drip tip and direct drip. It's yummier anyway.

<3
E.
 

tmcase

ECF Guru
ECF Veteran
Verified Member
Apr 20, 2011
20,862
54,652
3 fixes:
1. crimp the metal on your atty a LITTLE BIT to stop the cart from popping out... if your atty is flimsy enough.
2. Take a hot thingie (Glue gun tip, smoking hot needle, soldering iron) and make a bump on the side of the cart with the heat to help hold it in.
3. Throw the cart away, get a drip tip and direct drip. It's yummier anyway.

<3
E.

Crimping worked. Thanks.
 
Status
Not open for further replies.

Users who are viewing this thread