a bit of a problem....

[omiedevise]

So I've invested in a provari, a km carto tank ss, some boge 510 3.0ohms cartomizers, and a couple of diff. liquids.. From what I've seen, I tend to like the juices with more vg, as much as possible. My question is, is there anyway to vape 100% vg without burning my cartomizers? Filling a cartomizer with 100%vg juice is close to impossible, and when done, will only last a couple of drags.. if I install the tank, will that solve the problem? If I make the punch holes too big, will they flood? (what is flooding?) Should I just forget about the tank setup and use atomizers? I'm not intro dripping every minute..just not my thing... Are there any 510 cartomizers that actually work good with 100%vg? Any tips, advice?

 

[dotma]

I use a lot of 100% VG and i have never had a problem with clearomizers (just have to tip em every once in a while to get it to wick better). You could also thin VG juice with a little bit of distilled water or pure grain alcohol (it takes very little to thin it out.)

 

[omiedevise]

I use a lot of 100% VG and i have never had a problem with clearomizers (just have to tip em every once in a while to get it to wick better). You could also thin VG juice with a little bit of distilled water or pure grain alcohol (it takes very little to thin it out.)

how many times can you refill them?

 

[MrGiggly]

I've double punched cartos in a tank and not had any leaking issues at 70pg/30vg. Sure someone more experienced will explain it better but I believe that with a tank you end up with a system thats under pressure. I find it kinda cool to see the little bubbles form at the punch hole after a draw. I'm sure I read on a vendor site somewhere a recommendation that you punch carts at least twice if using thick juices. Worth experimenting a little to see what happens.

 

[Retriever]

I have heard that adding distilled water helps as well.