A Total Noobie Level Question.....

Status
Not open for further replies.

WillieB69

Ultra Member
ECF Veteran
Verified Member
Aug 4, 2010
1,412
2,133
Mt. Pleasant, Iowa
I almost feel embarassed about asking this because I should probably know better as long as I've been at this. Unfortunately, several searches here and elsewhere have not lead to my answer.

For several years I used eGo Twists with standard 2.5 to 3 ohm cartomizers. Recently I upgraded to an ipv D2 with a Kanger Subtank Mini.

I still have 3 or 4 boxes of the old cartos lying around and I was wondering if I could use them on the D2 at a low wattage without blowing anything up. .... Or at the very least, setting it on fire. If not, it's no big deal but I was curious if I ever got in a pinch.

Any input is greatly appreciated.
 

crxess

Grumpy Ole Man
ECF Veteran
Verified Member
Sep 20, 2012
24,438
46,126
71
Williamsport Md
Yes.
Okay, what you will need to do is place the D2 into TC mode
Attach your topper with its kanthal coil
Press -/+ together and release
Set Temp to Max - 585F ? not sure
Adjust joules 10j-50j as needed (same as setting watts)

vape as normal

Will NOT regulate temp while using Kanthal

Vape safe!
:D
 

r77r7r

ECF Guru
ECF Veteran
  • Feb 15, 2011
    13,653
    22,632
    Pa,LandOfTaxes
    Yes.
    Okay, what you will need to do is place the D2 into TC mode
    Attach your topper with its kanthal coil
    Press -/+ together and release
    Set Temp to Max - 585F ? not sure
    Adjust joules 10j-50j as needed (same as setting watts)

    Vape as normal

    Will NOT regulate temp while using Kanthal

    Vape safe!
    :D


    Wasn't there NiChrome or something in some of the earlier toppers? Same set-up for that I suppose?
     

    WillieB69

    Ultra Member
    ECF Veteran
    Verified Member
    Aug 4, 2010
    1,412
    2,133
    Mt. Pleasant, Iowa
    OK, I looked into workarounds for the step down and all that.
    No matter what I do with it, the mod will not fire in TC mode with the cartomizer. I hit the button and it says, "NO JUICE." I put it back in VW (power) mode, dropped the wattage down to 7 (lowest setting) and it fired like normal with the carto. It read 2.7 ohms at 4.8 volts and vaped pretty well. I don't think I want to do it on a regular basis but it did work. No burnt taste and a fairly decent amount of vapor for a standard carto.
     
    Status
    Not open for further replies.

    Users who are viewing this thread