About to get RSST quick question :)

[Vash]

About to pick up my first rba .Im getting a RSST and 400 mesh and 30 gauge kanthal A1 wire.

So my question is what kind of ohm difference should I see using 3 wraps vs 4 wraps ?

I want to end up between 1.0 ohms to 1.5 ohms.The lower the better .I understand more wraps equals higher resistance.Im just wondering how much difference I should expect.Thanks in advance

 

[Chikenbok]

1 Inch of 30 gauge Kanthal will give you .7ohms so that might be a good starting point for ya!

 

[Vash]

1 Inch of 30 gauge Kanthal will give you .7ohms so that might be a good starting point for ya!

So wrapping 4 coils about how long is that?

 

[Vash]

I have no idea but guessing 3 wraps will get me right around 1 ohm ?

 

[Chikenbok]

Depends on the diameter of the wick but if you measure the length before you put it into the wick you can always be spot on, especially if you have an ohm meter. a 3-4 wrap of 30g will give you *around* an ohm, a bit above perhaps depending.

 

[Vash]

Depends on the diameter of the wick but if you measure the length before you put it into the wick you can always be spot on, especially if you have an ohm meter. a 3-4 wrap of 30g will give you *around* an ohm, a bit above perhaps depending.

Ok thanks Yeah picked up multi meter to test coil after wrapping.So sounds like 3 to 4 wraps will be perfect for me.I have gg clone and Smoktech Bolt so thinking around 1 ohm should be perfect to get some nice big vapor clouds on either one