Added the VA VV Mini Mod

[muldrick]

Same as the VA VV Mod, just smaller:

Part Number 235

Similar to the regulat VA VV mod, this unit is smaller and takes 1 X IMR18350 battery. Available in Black only. 2 Buttons allow you to select voltage from 3 volts to 6 volts, in 0.1v increments Pocket Friendly Design: Hold the button down for 5 seconds to turn the device on, hold the button again for 5 seconds to turn the device off. Regulated output keeps the voltage the same regardless of the remaining battery power. As the battery drains, the device will keep the voltage consistent. 10 Second Cutoff timer: If the activation button is held down for 10 seconds or longer, the unit will shut itself off until the button is released to prevent overheating the atomizer and the device. Short Circuit/Atomizer Protection: The VA Tube Mod can recognize an atomizer with a resistance too low for the current voltage setting and will drop the voltage to 3.7v to protect both the battery and atomizer. If the atomizer is too low or shorted out power will be shut off to protect the VA Tube Mod from being damaged. Reverse Battery Protection protects the device in case you put the battery is installed backwards. Battery Monitoring/Over-Discharge Protection: The device will monitor the battery voltage and automatically turn off when the battery is discharged, preventing damage to the battery by overly depleting it. The VV Tube Mod includes a voltage meter in the LCD display, simply press the red power button 6 times and it will display the voltage of the battery for a few seconds allowing you to monitor the power left in the battery before it needs to be recharged. The 2 included 18350 High Drain batteries provide 4.2V at peak charge that will decrease to about 3.3 volts with use, before needing to be recharged. This will help you monitor the life cycle of the battery. The LCD screen will flash when the battery needs to be recharged, and will stop powering the device. Vent hole on the bottom of the device for added safety. Dimensions: 3.75"L x 0.86"D​ [*=left]1 x VA Variable Voltage Tube Mod - Body Unit [*=left]2 x High Drain 18350 Battery [*=left]2 x 510 ATOMIZERS- 3.0 oHm [*=left]1 x 18350 Battery Charger 1 x Carry Case ​ Be advised that the batteries in this device are Lithium Cells. We duly caution you that the nature of lithium ion batteries requires the use of a lipo sack, as lithium cells are known to possibly ignite while charging. By purchasing this device, the included batteries and the charger you acknowledge that charging lithium cells is not without risk. We highly recommend that you charge your batteries inside a 'Li-Po Charging Sack' or within a closed biscuit tin with gas vent holes drilled in it. The Li-Po sack or tin MUST be placed on a non-igniting surface such as tiles or stone. It must NOT be placed on wood, carpet or a worktop. Do NOT charge batteries unattended. Do NOT leave batteries on charge once fully recharged. UNPLUG the charger when finished charging your batteries​