Howdy folks me again.
Yesterday after waiting a whole two days with Breathless-Anticipation we received our shipment from Good Prophets. Excellent super fast service and shipping - good job fella's.
Specifically we bought the Five pack of eGo 2.4ml CC CE4 Clearomizers. These are at 1.8ohms which was my first experience using an LR setup on our eGo systems. I found out quickly how some eJuices weren't meant to be vaped at such High Wattages - even though technically you cannot classify something as too high a wattage just sitting around 6 Watts or so (am I missing something(?)). That is besides the point at the moment.
I used a total of four of the Clearos to test out some of the new ejuice flavors we bought. Of the four I used, the Yellow one Holding French Pipe tobacco flavor is leaking near the bottom of the unit where the Plastic tank/Cylinder is joined to the metal bit that connect to the eGo's Collar.
My question is this, is there an adhesive or Sealant that I can use to re-inforce the SEAL between the plastic tube and the metal eGo collar fitting?
And experience or knowledge with this would be greatly appreciated.
Thanks for your time
Tim
Yesterday after waiting a whole two days with Breathless-Anticipation we received our shipment from Good Prophets. Excellent super fast service and shipping - good job fella's.
Specifically we bought the Five pack of eGo 2.4ml CC CE4 Clearomizers. These are at 1.8ohms which was my first experience using an LR setup on our eGo systems. I found out quickly how some eJuices weren't meant to be vaped at such High Wattages - even though technically you cannot classify something as too high a wattage just sitting around 6 Watts or so (am I missing something(?)). That is besides the point at the moment.
I used a total of four of the Clearos to test out some of the new ejuice flavors we bought. Of the four I used, the Yellow one Holding French Pipe tobacco flavor is leaking near the bottom of the unit where the Plastic tank/Cylinder is joined to the metal bit that connect to the eGo's Collar.
My question is this, is there an adhesive or Sealant that I can use to re-inforce the SEAL between the plastic tube and the metal eGo collar fitting?
And experience or knowledge with this would be greatly appreciated.
Thanks for your time
Tim