Advice needed for Nautilus rebuild and MPV2

[XXFa113nXX]

Hello my friends!
I'm currently rebuilding coils on my nautilus. I'm pretty much following RIP Trippers build but with a twist >
I'm using a single layer of 500 steel mesh instead of the cotton on the inside and the same mesh for the wick. Now I love huge clouds. I would love to get the max vape without burning my juice. What's the best ohm resistance in your opinion? I was shooting for 1.2 ohms but since I have a Innokin MPV2 I'm not sure if it will handle it. What's the max amp output of the MPV2 and if I do build a 1.2ohm single coil, how many volts/watts should I be vaping at? I would love some expert input on making a constant quality build and advice on if I should stay with the MPV2 or go bigger. Thank you all for the help and keep on vaping!

Aspire Nautilus
Innokin MPV2

 

[issy]

I don't have any advice because I haven't purchased the nautilus or mvp2 yet (both on my list!). Just wanted to bump and say that I like your set up, and I'm curious to know the best settings as well!

 

[steved5600]

My advice is get a RBA. I have the nautilus and it's pretty good it's just to much of a pain to rebuild well. lots to go wrong. I would first off not use mesh for your wick. Just for the wrap only. It's hard enough to keep from having a short somewhere. Also you need to be using NR-R-NR wire so your leads are less likely to get hot when you do heads. Hope this is of some help.

 

[VaPreis]

The MVP tops out at a 3 amp output. (not much)

My favorite builds have been for higher resistance on it using thinner wire like 29 or 30ga, 1.5-2.0Ω.

Current Kayfun build for the MVP is 29ga wire at 2.1Ω going the full 11 watts.

 

[XXFa113nXX]

Thanks everyone for the advice. I want to do RBA and get a good setup going. So I think I'm gonna aim for a clone first and then go to a good one like the kayfun or Russian 91%.

Aspire Nautilus
Innokin MPV2