I picked up this Airlab rda from fasttech, and it doesn't seem to be a clone, as I couldn't find a single review or video on it other than those ones the Chinese manufacturers post with no commentary where they unbox and display the piece for reference.
It's quite a nice rda for the less than $10 it cost. The chamber is small, but roomy enough for a 3mm coil (just), it's not overly airy, and the screws hold a fused Clapton (38g over 2X30g cores) reasonably well. My next build in it will be a round wire build, probably 28g around 1 ohm. I included a few pictures from the website, but my dripper came as pictured without any visible defects and minimal machine oil smell.
It's basically an 18mm RDA with a 22mm beauty ring that functions as the airflow control. Does anyone else have experience with this one?
Sent from my SM-G930T using Tapatalk
It's quite a nice rda for the less than $10 it cost. The chamber is small, but roomy enough for a 3mm coil (just), it's not overly airy, and the screws hold a fused Clapton (38g over 2X30g cores) reasonably well. My next build in it will be a round wire build, probably 28g around 1 ohm. I included a few pictures from the website, but my dripper came as pictured without any visible defects and minimal machine oil smell.
It's basically an 18mm RDA with a 22mm beauty ring that functions as the airflow control. Does anyone else have experience with this one?
Sent from my SM-G930T using Tapatalk