All I need to know about a Nemesis

[lopenator]

Hello ECF Community,

I do apologize if this is in the wrong section on the forum.
I recently ordered a mechanical mod, the Nemesis, and it is on it's way to me in the mail. I know (not in great detail) the basics of the safety when using a mech mod. Maybe someone can further educate me.

I am aware that if I'm sub ohming, I cannot go below a specific ohm depending on the battery. Why? What determines this? And is there a maximum limit? I know I cannot stack batteries. I know I cannot fully discharge the battery (why?) What happens if I do and how do I know when to stop vaping when using my mech due to a battery discharge if I will not know the volts it has left?

Is there anything else I should know? I do plan on sub-ohming as I've seen some pretty large clouds due to it. I would like to use micro coils.

 

[State O' Flux]

Click on my second sig line hyperlink... and start reading. Experienced, successful and safe RBA and mech users understand, at least the basics of - Ohm's Law, battery maximum continuous discharge amperage or 'C' ratings, battery safety and the facts about Kanthal wire and coil modeling / building.

If you have any remaining unanswered questions or need clarification... post in the appropriate sub forums. ;-)

APV Discussion

Rebuildable Atomizer Systems

Coil Builds

 

[lopenator]

Thank you very much

I have a basic knowledge on electricity.

 

[State O' Flux]

Thank you very much

I have a basic knowledge on electricity.

That's good... it will make understanding the need for resistance and amperage "balance" much easier than if you did not. ;-)

 

[lopenator]

So I can basically just follow that battery chart that has all the info for all the different batteries on it and ill be safe as long as im not stacking?