Altoid "Box" Mods

[jwibbity]

Here are a couple I built over the last couple of weeks in my spare time, the first is a dual 18650, with a FDV V4 510 connector, I've ran it down to .15 ohms and it works like a champ. Originally this was all going in the 1590G box but I made the wires off the mosfet too long and didn't feel like doing it over so I grabbed the closest altoid can and threw it in

The second one which I built last weekend has a single 18500, mosfet, with a micro usb charger, can only run it down to .4 because of the battery but it gets the job done. The slot for the micros usb is a little hacked up just because I didn't have the right tools on my dremel.

 

[rhelton]

Nice I like em. Is that a 18500 in the little one? Looks nice and stealthy. The easiest way to do the charger openings is get a set of needle files they are about 2 bucks at harbor freight, you just drill a little hole and file the rest out works great.

edit:

duh I see after I read its a 18500

 

[jwibbity]

Nice I like em. Is that a 18500 in the little one? Looks nice and stealthy. The easiest way to do the charger openings is get a set of needle files they are about 2 bucks at harbor freight, you just drill a little hole and file the rest out works great.

edit:

duh I see after I read its a 18500

yea thats what I'm thinking about doing, What I did was use the drill bit like a router bit and you can see the results from that so next time I will be using files, thanks!