Well I dropped my Ego twist today and like another poster here a wire has now broken loose. Can some of you electronics Guru's please take a look at the below linked full size images and tell me if I have selected the right spot to solder the broken wire? Until my VAMO gets here, this is my best device.
Original photo:
http://imageshack.us/a/img837/4647/img20130111173219.jpg
Red circle shows broken wire.
Yellow circle shows where I "think" it should be soldered.
http://imageshack.us/a/img809/5905/circlesadded.jpg
(EDIT) The wire attaches to the inside of the head piece like a ground wire. I am in the process of using some JB-Weld to re-attach the metal head piece to the battery tube. Maybe won't look so great but it vapes just like it always did so I am happy. Thanks for all the suggestions, I never thought about it attaching to other than the circuit board.
Original photo:
http://imageshack.us/a/img837/4647/img20130111173219.jpg
Red circle shows broken wire.
Yellow circle shows where I "think" it should be soldered.
http://imageshack.us/a/img809/5905/circlesadded.jpg
(EDIT) The wire attaches to the inside of the head piece like a ground wire. I am in the process of using some JB-Weld to re-attach the metal head piece to the battery tube. Maybe won't look so great but it vapes just like it always did so I am happy. Thanks for all the suggestions, I never thought about it attaching to other than the circuit board.
Last edited:
