Any Can Sup carry drip shields ?

[Northernshrink]

Title says it all havent found any Canadian suppliers for these yet but guessing someone carries them.

 

[DevilFishPhil]

There are 2 that I know of:

HappyVaper
VaporGeek (site appears to be down so i can't link)

 

[Northernshrink]

There are 2 that I know of:

HappyVaper
VaporGeek (site appears to be down so i can't link)

Thankyou Sir !!

 

[DevilFishPhil]

My pleasure sir

The VG DSs have nicer designs, but the one from HV which is the same one sold by AvidVaper is of slightly better quality IMO.

 

[VapesAlot]

just got one from VG today. works fine but really tight draw. think the shield should be a little bigger on the round to allow air flow around carto. but over all good shield for the price, only $7.50

 

[mrman]

just got one from VG today. works fine but really tight draw. think the shield should be a little bigger on the round to allow air flow around carto. but over all good shield for the price, only $7.50

i wonder if you can just drill out the holes to a bigger diameter.
i was going to get some for my "starter", as some say, collection of goodies.

 

[VapesAlot]

i drilled the holes bigger but its a snug fit around atty, i know the rubbers are tight but there isnt much room around the shield and atty. if you have a flush 510 connection you will also need a 510-510 sealed connoctor. i found this also tigned up the draw. my omega has a 4 slot 510 connector and the sealed 510connoctors are only 2 slot makeing a tighter draw. it almost feels like if you roll a analog cig really tight and you have to suck really hard. may tinker with it tommorrow and seeif i can looseing it up

 

[mrman]

i drilled the holes bigger but its a snug fit around atty, i know the rubbers are tight but there isnt much room around the shield and atty. if you have a flush 510 connection you will also need a 510-510 sealed connoctor. i found this also tigned up the draw. my omega has a 4 slot 510 connector and the sealed 510connoctors are only 2 slot makeing a tighter draw. it almost feels like if you roll a analog cig really tight and you have to suck really hard. may tinker with it tommorrow and seeif i can looseing it up

dang, guess i will try and find a different one, thanks for the info.

oh, i think i hijacked this guys thread, my bad.

 

[Cobber]

So on a lava tube would I need an adapter?

 

[r4nd0mCh40s]

So on a lava tube would I need an adapter?

with all 510 connections, you should use a 510-510 adapter most dripshields are made for 306's

 

[DevilFishPhil]

Actually the drip shields were originally meant for the 901s (which are much more prone to leaking).

Yep the VG DS is very snug and tightens the draw tremendously - I recommend trying the one from HV (you can also get it from AvidVaper) it's a bit less snug and with 4 holes at the top it barely affects the draw.

 

[VapesAlot]

So on a lava tube would I need an adapter?

yes you will need a connoctor

 

[kellyd]

If you get a connector make sure the connector is sealed or its defeating the purpose of the drip shield.

 

[VapesAlot]

drilled my shield, now has 4 holes and a little bigger. the draw is still a little tight but alot better with 4 holes, now its a good shield but wish it was chrome instead of alumium color.