Any glass tank Kayfun style RBAs?

Status
Not open for further replies.

Nomoreash

Vaping Master
ECF Veteran
Verified Member
Aug 9, 2010
3,261
931
Chattanooga, TN
Threading is most likely the issue with glass on a Kayfun. If it was just a glass tank it would have already happened by the manufacturer or someone else. I don't see getting threads that fine on glass, cheaply anyway. They could make the threads much wider for glass but then they would have to rework everything.
 

edyle

ECF Guru
ECF Veteran
Verified Member
Oct 23, 2013
14,199
7,195
Port-of-Spain, Trinidad & Tobago
I ordered one.

Fogger V3: 6 ml, 510 drip tip (kayfun doesnt use standard drip tip), glass tank.

1582000-1.jpg


Details:

•Stainless steel 510 drip tip
Clear glass tank
•Stainless steel protective shield/sleeve
•4 airholes located on lower body
•With air flow control ring
•510 connection with adjustable center pin
•Pre-assembled mesh
•Uses 0.5 to 3.0 ohm coils
•Height without drip tip: 56.4mm/2.2" (Approx.)
 

Jailbird

Senior Member
ECF Veteran
Verified Member
Dec 4, 2013
92
116
Wisconsin
1010204_400106763458477_1438666120_n.jpg


That's also running a replacement top cap but you get the idea.

I just saw this setup on FB last evening. A buddy of mine runs a shop in Chicago and posted an interest thread. I will definitely be picking up a few if these kits. Do you remember about what the cost was?

Sent from my SAMSUNG-SM-N900A using Tapatalk
 
Status
Not open for further replies.

Users who are viewing this thread