Any suggestions for cleaning the smell/taste off of the protank rubber grommets?

[thomas.egnoto]

I've been using pluid with my protank, and I've unfortunately used all my atomizers with pluid, so they all smell pretty strongly of it. I was going to boil/dry burn/boil one of the atomizers to try and get the taste out, but every time I've done that in the past I had no idea how to get the smell of pluid out of the rubber grommets that go over the protank wicks. I'm afraid they'd melt if I boil them. Anyone have any suggestions? I'm assuming it'll be really leaky if I don't use the grommet at all (I get occasional leaking even with it).

 

[RubyRoo]

They are silicone, so they won't melt if you boil them. I soak mine, along with my atomizer heads in vodka for a few hours, then rinse with really hot water. I think boiling everything would work well for you! Definitely continue to use your silicone grommets on your heads, otherwise, you will get flooding and leaks. Hope this helps!

 

[EvilZoe]

Soak in Everclear then boil them for a while.

Check into getting new rings for them, too. Kanger rubber O ring – KangerTech

 

[Margate69]

As stated above they shouldn't melt when boiled.

I use Taka vodka- cheapest cleaner around!

 

[vaperature]

What is a pluid?

 

[EvilZoe]

What is a pluid?

It's a heavy-duty e liquid that has a very strong flavor and loves to leave its ghost wherever it has been...lol

Pluid 30 ML 20Mg

 

[Margate69]

It's a heavy-duty e liquid that has a very strong flavor and loves to leave its ghost wherever it has been...lol

Pluid 30 ML 20Mg

Glows green? And you want to vape it? LOL.

 

[EvilZoe]

Glows green? And you want to vape it? LOL.

Well, I don't. I'm not fond of that sort of flavor...lol