Any tips on how to improve airflow on the did atty?

[badinfluence357]

Need tips and ideas on how to improve the airflow on the did atty!!
They have reuduced the hole to 1mm on a new cap that there selling but its a lil to much money to pay just for a smaller hole so im open to ideas!

Ill start it off..........

You can roll up your ss mesh with a piece of 1mm fiberglass wick inside of it.

 

[mike n]

You can hook up your wire between the bottom and middle screw and use the top screw to move it higher or lower and that will ajust airflow. Just don't go too high or you won't get any airflow. Also there is a whole forum you may want to read with all DID users. Do a search for....

New Genesis type atomizer by DID!

Mike N

 

[badinfluence357]

Thanks mike.....ill check it out

 

[Cloud Wizard]

Based on a tip from the DID thread, I drilled original 3/64in hole in my cap with a 1/16in drill bit ($3 for 2 @ Home Depot: Milwaukee brand - Split tip, titanium). It literally took 10 seconds. I also used a wide mouthed drip tip (Super-T makes some pretty cool ones)

 

[ricklynchcore]

As mentioned in another post, go to the euro suppliers area, and check out the DID thread, it literally contains just about everything you ever wanted to know about the DID. Just tons of innovative ideas and tricks, from users and the mod maker. Enjoy.

Sent from my cm_tenderloin using Tapatalk 2

 

[Cloud Wizard]

link to the thread: http://www.e-cigarette-forum.com/forum/euro-suppliers/296166-new-genesis-type-atomizer-did.html

 

[badinfluence357]

QQQ]©l

sent from outer space using my vaperbotron 5G speed of vape!