Any way to "pretty up" gap between e-Power 14650 and 3.5ml DCT?

[John D in CT]

I can't go out of the house looking like this:



I mean really, what would the neighbors say if I walked around with my threads showing?

Anyone know of an available trim piece to neaten up the look?

Quick, before this gets moved to "Where can I get ...."

Thanks!

 

[Killjoy1]

That's got an eGo connector on it, right? With threads for the atomizer cone? There are pieces designed to streamline the look of the smoktech tanks, they may work fine for that, too.

eGo Chrome Cone for the 3.5 mL Dual Coil Tank Cartromizer
eGo Chrome Cone for the 5 mL Dual Coil Tank Cartomizer


A couple other vendors have them, too. Some call them "cones" and other "plinths"

 

[John D in CT]

That's got an eGo connector on it, right? With threads for the atomizer cone? There are pieces designed to streamline the look of the smoktech tanks, they may work fine for that, too.

eGo Chrome Cone for the 3.5 mL Dual Coil Tank Cartromizer
eGo Chrome Cone for the 5 mL Dual Coil Tank Cartomizer


A couple other vendors have them, too. Some call them "cones" and other "plinths"

Hey, thanks for that. That'll be just the thing for my Joyetech eGo batteries, which have the same affliction. Won't fit the 14650 though; I should have made it clearer that the Smoktech 14650 e-Power has 14mm outer threads, where the Joyetech eGo is 12mm. I'll keep looking around - maybe they don't exist yet, in which case I'll just get over it. Sure looks nicer with a "plinth" though.

Thanks again

 

[Killjoy1]

Ah, didn't realize the dimensions were different, there.

 

[Cheechako]

I found out the hard way the dimensions were different than the Ego...Doh!