Anybody have experience with a Postless RDA?
- Thread starter golfer23
- Start date
- th_trl_thread_readers 0
- Status
Depends on the design I guess. I think it would be more difficult to build, but I'm not sure because I've never used one.
I have one! I bought a big ago.
Lots of spit back due to being a similar size as the Derringer.
I actually havent been able to use it much...
The ohms are jumping, Which makes me assume that one of the screws is loose, But I cant tighten it because I lost the little allen key thing, , and it was a strange size... so, none of the other ones I have for my other RDAs work.
Leaks.
If I were to give a tip.... I would say leave it. Its gimmicky, But thats about it. I do not really see any other benefit to the postless, except that it looks kinda neat.
Lots of spit back due to being a similar size as the Derringer.
I actually havent been able to use it much...
The ohms are jumping, Which makes me assume that one of the screws is loose, But I cant tighten it because I lost the little allen key thing, , and it was a strange size... so, none of the other ones I have for my other RDAs work.
Leaks.
If I were to give a tip.... I would say leave it. Its gimmicky, But thats about it. I do not really see any other benefit to the postless, except that it looks kinda neat.
I don't have a postless yet but I have seen quite a few on eBay and reviews on you tube.
Personally I see a lot of pros.
1. The coils are closer to the deck so the capillary action of the cotton will work better because the shorter distance to travel.
2. If the airflow I'd midway up the side would be less likely to leak.
3. Since the wires go into the deck you are less likely to mess up the coils
4. The postless deck has fallen screws holding the coils and generally Allen screws are less likely to cut the wires.
The only downsides I see are
1. Will gurgle if you over drip.
2. Possibly a problem if they use Delrin instead of peak for the insulator.
I have one! I bought a big ago.
Lots of spit back due to being a similar size as the Derringer.
I actually havent been able to use it much...
The ohms are jumping, Which makes me assume that one of the screws is loose, But I cant tighten it because I lost the little allen key thing, , and it was a strange size... so, none of the other ones I have for my other RDAs work.
Leaks.
If I were to give a tip.... I would say leave it. Its gimmicky, But thats about it. I do not really see any other benefit to the postless, except that it looks kinda neat.
Should you find the Allen key; try pulling the coils toward the wall and spitback will be less. At least that is how I solved the spitback on my Rogue top airflow atty.
I don't have direct experience with a post less one, RIP Trippers Review is anyway worth to see
- Status
Similar threads
