So I've had my MVP for about a year now, and just yesterday, I accidentally dropped the piece on my marble floor. The top broke off leaving a piece of the part where you screw in tops. I managed to screw that part out using some tools. However, now there is a new problem. The MVP is completely intact, I can easily screw tops in and out, however when I click the power button (the one that should start the vaping) nothing happens. In fact, usually when I do this, the button will glow green only as long as I hold it, but right now, if i click it once, it will stay green for about 10 seconds, and then just stop glowing. I can still change the voltage on the side, and the piece is still entirely intact, however it will not produce vapor, I can't turn it on or off (but clicking the power button 3 times), and when clicked it just glows green for a while then stops. Has this ever happened to anyone before? Could it be due to the fall that it took? Is there a fix to this problem or is the MVP fried?
Anyone have a lot of experience with the iTaste MVP?
- Thread starter XiPassiX
- Start date
- th_trl_thread_readers 0
- Status
Sounds like you did some damage to the inner circuit board of the MVP during the fall. There is no fix.
That's a shame. It's so odd though, how it seems like it if I could maybe just unscrew it and wiggle the switches around maybe it'd fix it. Cause it literally has no other problems except that.
What broke off? If the entire eGo/510 connector came off - including the center post - you broke all connecting wires providing power to the 510 connector. Attaching it back onto the body won't fix that. It needs a full disassembly and some soldering.
What's it say on the display when u click the button? Once in a while mine says "non" then I know the beauty ring has unscrewed enough to not allow contact with the atty. make sure ring on top is screwed tight to base then atty screwed tight to top and try again. Good luck! Try different Atty too.
- Status
Similar threads
- Locked