Anyone make a BCC that has adjustable draw?

[venemous]

I find I prefer a different draw depending on the flavor I'm vaping. Did a little google-fu and haven't seen anything. Seems it would be a pretty simple thing to make... Anyone aware of any out there?

 

[Yinzer]

The positioning of the air holes on the Kanger T3S allows me to create a tight or airy draw pretty easily.

 

[State O' Flux]

You can cover 1-2 air holes on eGo threaded clearos with 3 holes. Back when I used clearos, I'd slide a short piece of surgical tubing over the base - at a bit of an angle and cover 1-2 holes. Hell... a piece of tape will do the same thing.

You can use a cut off piece of a carto condom to slide down over the outside of a 510 collar and cover 1-3 of the 4 air notches... same kinda deal. ;-)

 

[venemous]

You can cover 1-2 air holes on eGo threaded clearos with 3 holes. Back when I used clearos, I'd slide a short piece of surgical tubing over the base - at a bit of an angle and cover 1-2 holes. Hell... a piece of tape will do the same thing.

You can use a cut off piece of a carto condom to slide down over the outside of a 510 collar and cover 1-3 of the 4 air notches... same kinda deal. ;-)

I've been doing this on my evods with a piece of tape, was really hoping for something that 1. is more integrated and 2. I don't have to replace every couple days.

 

[State O' Flux]

I've been doing this on my evods with a piece of tape, was really hoping for something that 1. is more integrated and 2. I don't have to replace every couple days.

I'm hip... something with a bit more style, and as you say, integration. I don't look much any more, but if I still had a lathe, I could make them out of SS... just a round "clip" with a few holes that you could turn to expose or cover holes. Someone will make something sooner or later, or you might, in your travels just accidentally come across the perfect thing. Good luck!

 

[venemous]

... just a round "clip" with a few holes that you could turn to expose or cover holes.

Exactly how I picture it working myself. I'm sure I'll run across something one of these days or I'll just stock up on scotch tape during the after christmas clearance sales...

 

[State O' Flux]

Exactly how I picture it working myself. I'm sure I'll run across something one of these days or I'll just stock up on scotch tape during the after christmas clearance sales...

It would be very easy to make them out of thick wall shrink tubing. Do them in assorted colors so you can ID the juice... or in clear if you just want them to blend in. Just don't accidentally do them with the heat set epoxy inside. ;-)