Lol....I pull out my Provari and a Protank every once in a while when I need a little extra nicotine.
Apollo E-cig contest/giveaway thread!!
- Thread starter a_rey88
- Start date
- th_trl_thread_readers 0
- Status
Try soaking it in white vinegar after you rinse it out, and don't forget to make sure the o rings get a soak, tooI usually have mine out everyday because I like the throat hit and like the way it vapes and I have coconut in it. Right now Im vaping some kind of fruit that taste like perfume - I think its melons and not very good and its hard to get the taste out of the tank - argh
Thanks - I never tried vinegar so I will give that a try. I have a small jar of vodka that I usually soak them in that helps a little but I will give the vinegar a go
It's still early days but I said I would show you how it's going.
I have a nice sheet of pewter to use for the final but until I get it right I am just practising on aluminium and I will still need to fill in the back and stabilise it on some velum. But it's a nice effect
I have a nice sheet of pewter to use for the final but until I get it right I am just practising on aluminium and I will still need to fill in the back and stabilise it on some velum. But it's a nice effect
I think, depending on the grade, I would prefer the aluminum over the pewter
That's pretty awesome! Looks very nice. I tried making some juice for the first time today. I'd say your results are better! lol
I think, depending on the grade, I would prefer the aluminum over the pewter
I don't quite know yet. I can polish the pewter, the aluminium will always be brushed finish.
don't loose hope....juice has a learning curve, but well worth it in the end
do you have a dremel?
If so, you can sand the aluminum down with super fine grit, then buff with a dremel polishing disk, and get a mirror finish out of it......
ROFL. I DIY and I mix up a batch of concentrate then use that for my mixing. Last lot I mixed I made a complete hash of it and ended up having to mix a total of 500ml of concentrates to fix it. I hope I never go off that flavour.
I think I am working too thin a sheet to do that. The sheet is only .3mm thick so that by the time I stalibize the raised section I don't have enough room. The BB panels are only .5 including glue tape.
We are completely set up to buff and polish (from the wood working) so have the tools.
Wow...I only tried 10 mls since it was my first time. It's not completely horrible. I can vape it. And it hasn't steeped at all. I'm letting it sit in some warm water for a little bit to see what that does.ROFL. I DIY and I mix up a batch of concentrate then use that for my mixing. Last lot I mixed I made a complete hash of it and ended up having to mix a total of 500ml of concentrates to fix it. I hope I never go off that flavour.
I have pretty much vaped the same 4 eliquids for the entire 4 odd years I have vaped. We can't buy eliquid with nicotine in it so DIY was the only way to get eliquid at a reasonable cost. When I started no country would ship to us....much easier now.
maybe just try doing the buffer wheel with a good polishing compound, could work
either way, even brushed finish It looks really cool
- Status
Similar threads
- Locked
