I just purchased a couple of Aspire BDc glassomizers, and I have loved them so far. I am having an issue though. There is a little pin that is on the bottom of the coil assembly and they have been falling out. When this happens there is no connection to my MVP2. It fell out in my pocket earlier today and it wasn't a big deal because I was able to put it back in and vape away. This time it fell out and I can't find it. Has anyone else experienced this issue,and if so is there a solution for it?
Aspire BDc Glassomizer issue
- Thread starter jjuice
- Start date
- th_trl_thread_readers 0
- Status
I have not had this issue and I have a good collection of these coils. The only issue I have had is the gurgling and leaking once it gets to about 1/3 full...........but to answer your question, yes; you likely have defective coils.
That pin holds in the rubber/silicone gromet that houses the legs of the actual coil and makes the connection with the battery. I would just put in a new coil or buy more. QC for these suck
That pin holds in the rubber/silicone gromet that houses the legs of the actual coil and makes the connection with the battery. I would just put in a new coil or buy more. QC for these suck
Are you overtightening the clearomizer when attaching to the battery? This might damage the grommet holding the contact pin allowing it to come out. Generally, the pin is very securely held in place.
I don't think so, just making it snug, but I will try backing off on how tight I snug it up. Thanks for the input.
- Status
Similar threads
- Locked
