I have 2 Aspire BDC tanks but after using my new protank IIs the aspire just does not have enough air flow for me. Before I write them off completely I wanted to see if there was a way to increase the air flow. Anyone know if it is possible? Thanks in advance!
Aspire BDC question
- Thread starter TAT191
- Start date
- th_trl_thread_readers 0
- Status
I'm really interested in this also. Aspire BDC,s are great little tanks but are a tight draw.
The best idea I can think of which have done with mini vivi tanks is drill out the three button holes one drill bit size up. This works with ego come thread style tanks only.
Like Aspire BDC CE5-S Ego - Kidney Puncher
Like Aspire BDC CE5-S Ego - Kidney Puncher
Someone more experienced could probably tell you if this would help with your problem, but when I got my aspire BDC tanks I also picked up a couple these Airflow Controller with 510 Threading that lets me raise it up for more airflow and tighten it down for less.
I drilled out one of the holes to about 1/8 of an inch. Other people I know drilled both holes out 1/16. Either way it helps improve the airflow a lot.
+1 for drilling here as well. I ran 'em stock for a while and decided to open up the airflow a little by drilling out one of the two holes in the bottom assembly (remove coil first!)
Was going to open up the second hole as well but just doing one made a nice improvement and seems enough for me.
Was going to open up the second hole as well but just doing one made a nice improvement and seems enough for me.
- Status
Similar threads
- Locked
- Locked
