I've got a few of the Aspire ET-S clearomizers and I've noticed some possible problems. First off is the excessive crackling when firing. Usually when it gets real bad I notice a lot of liquid built up on the bottom of my unit (MVP 2) where the could screw into the APV. I was told this is caused from vaping to hard and for a long time. Average time is about 7 seconds Im firing and inhaling. And secondly is when vaping off the ET-S i sometimes feel like a hard substance entering my mouth. The best way to describe it is small little ice crystals hitting my tongue and throat. What's going on with that?
Aspire ET-S clearomizer problem?
- Thread starter cfyre0815
- Start date
- th_trl_thread_readers 0
- Status
I have 3 Aspires (BDC) very similar. One of them spits juice, crackles and pops with any draw... The other two do fine, I'd venture to say the "ice crystals" you are describing are really molten lava from a long draw. (ok, hot juice)
My average drag lengths are about 7 seconds so I'm guessing that's why it's getting so warm and doing that.
I have a few of these too, I noticed more issues with the BDC Coils vs the Interchangable BVC Coils.. I like the way they hit though, sometimes taking it apart and getting the excess juice out helps. Possibly a thicker Blend of eLiquid could help too, More VG in the Blend than PG will work wonders sometimes.
I use the ET-S BVC too. I've used mine with the BVC and BDC coils. I only have this issue when I go over 4.3v. I just hang out between 3.8-4.1v, and haven't had an issue since. Well, no issue with the crazy crackles since.
I still have occasional gurgling. I just shake that .... upside down for a bit, take a few dry puffs with a tissue over the tip, and when the draw is smooth and dry, I go back to gurgle-free vaping.
I still have occasional gurgling. I just shake that .... upside down for a bit, take a few dry puffs with a tissue over the tip, and when the draw is smooth and dry, I go back to gurgle-free vaping.
- Status
Similar threads
