Aspire Nautilus Coil washing when changing flavor

[d1jey1]

Hi all

Long time Vaper and Ecf follower but new user.

Question: How do you suggest to clean the coil when I want to change the flavor? I tried to search on the forum and can't find any input on it yet. When I.uses Protank, and I usually just run stream of water through.the coil for few minute when I change the flavor...Of course with Protank I'm also.able to dry-burn it as well if needed. Thanks for the help all

 

[cyberwolf]

You could use water, but try to dry it out as much as possible. I actually keep some pure grain alcohol (PGA) around for this purpose. That dries quickly just sitting around for a bit. When just changing flavors I often just dump everything out of the tank and use a paper towel to absorb as much off of the wick as I can, but my typical tobacco juices don't leave much of a lasting flavor.

 

[CreepyLady]

Hi and Welcome to ECF

Hot water oughta do the trick unless its just a tough flavor to get out. Def wouldnt try a dryburn on it.

 

[bamboozer2]

Hi, also a new ECF user here but not new to the info.
The only wick i ever dry burn is stainless mesh to clear off the gunk. As long as your using a non combustable wick such as silica, stainless mesh, or eko wool (not cotton ) your safe to dry burn but its really not necessary in a pro-tank. grain alcohol is excellent and fast drying to clear out juices.
-happy vaping

 

[d1jey1]

Thanks for the quick reply... i usually just ran stream of hot water on my previous protank... so is it safe to do th same thing with this coil? I think i kindda recall from the manual to not wash the bdc part.. unless i misunderstood what it meant..