Aspire Pegasus issues.

[corNIC]

Hey all!

So recently my innokin SVD finally died after using it for over a whole year solid. It still works but the 510 threads finally stripped out lol.

Anyways.....I have now the Aspire Pegasus and a Aspire Nautilus tank that I carried over from my SVD. Overall I really like the device but I have one exceedingly annoying problem with it.

When I swap batteries (I have two that I swap daily basically). This happens with both my samsung batteries and they are both brand new. The Pegasus runs at like 7.5V on a 1.6ohm coil. Basically this burns the crap out of my coil almost to the point I can't use it anymore I have tried manually adjusting the wattage etc but it remains at 7v no matter what for about 10 presses or so. It burns so hot there is no way I'm taking a hit off it when it's like this. Then after that it just seems to kick back down to where I normally have it set which is anywhere between 9-12W which equates back to around 4.1V. Anyone else had this issue? I am wondering if I need a new tank perhaps . This wouldn't be that big of a problem but it seems to almost ruin my coil everytime I swap the battery which is a total nuisance.

Thanks for your help!

 

[Susan~S]

I have tried manually adjusting the wattage etc but it remains at 7v no matter what for about 10 presses or so. It burns so hot there is no way I'm taking a hit off it when it's like this.

Try turning the battery off for 5 minutes and then powering it up again. Maybe that would help.

If not, sounds like you have a defective mod. When you change the wattage your voltage should also change.

 

[Mooch]

There's been some chatter regarding the Pegasus' 30W pulse, for a few seconds, used to determine what type of coil is being used. Perhaps that is what you're seeing. Check out the forums at Aspire - Best E Cigarette, Clearomizer, Tank, nautilus for more info.